Silikonlu Grenli Dış Cephe Boyası


> Silicone and patterned water-based exterior coating. It is a long-lasting, thin and thick patterned facade cladding material that can be used both inside and outside, which is applied with a roller and patterned with a roller, which covers surface defects with the pattern and thickness it creates.



> With its high water repellent ability, it allows the rain water hitting the facade to flow off without wetting the surface.

> With its high water vapor permeability, it allows the buildings to breathe by being thrown out without blocking the water vapor.

> Covers surface defects with the pattern and thickness it creates.

> Does not absorb, swell, crack or fade from heavy weather conditions such as rain, snow, humidity, extreme cold or heat.


> On the exterior, it can be applied to mineral surfaces such as black plaster concrete cement board and old painted surfaces, and to interior surfaces with its decorative appearance when desired.


>It should be checked that the surface is sound, dry, clean and able to support itself.

> Dust, dirt, old and swollen layers that reduce adhesion on the surfaces to be applied must be completely cleaned.

> Before applying on new mineral surfaces, the surface should be allowed to dry.

> Surface smoothing repairs should be used appropriately where necessary.

> Exterior wall putty should be used for repairing and stripping hairline cracks.

Silikonlu Grenli Dış Cephe BoyasıAPPLICATION

> It should be primed with mineral based ACRYLIC PRIMER or SILICONE PRIMER.

> It should be done at least 24 hours after priming.

> It can be applied as a single layer without thinning.

> When two coats are required, 10-15% of the first coat is applied without diluting the second coat.

> It can be applied to the surface with any kind of roller (patterning with a coral roller is recommended) or by spraying.

> Care should be taken to ensure that the surface temperature is between +5°C and +30°C during application.

> Wait 4 weeks for newly plastered surfaces.

> Depending on the weather conditions, at least 12 hours should be waited between coats.

> With the application, a thickness of 1.0-1.5 mm is obtained.


> Final drying : 24 hours


> It can be stored for 2 years in its unopened package, in a cool and dry place, protected from direct sunlight.